Installation and acceptance of common faucet parts

2020-08-08 10:03:49

First prepare to place things, check whether the matching parts are complete before placement. Common faucet parts are: hose, rubber washer, shower, drain, abductor, decorative cap, etc.


Installation of single hole basin faucet


When purchasing single handle hand basin faucets, you should pay attention to the diameter of the water outlet. Nowadays, most parts of the market belong to hard pipe water inflow. Therefore, you should pay attention to the reserved height of the upper water outlet, which is 35 working points from the basin to the bottom. When installing, the special angle valve must be selected, and the angle valve must be firmly connected with the hot and cold water pipe of the wall water outlet. When you invent that there is a gap between the angle valve and the tap water pipe, buy a special extension pipe to connect. Remember, definitely do not use other water pipes to connect, because if the water pressure is large, it is easy to fall off, leakage, to cause you loss. If the inlet pipe is too long and over the outlet pipe, you can cut off the department according to your need. If the angle does not conform to the requirements, it can be bent to your necessary position according to the necessity. Remember: don't bend hard to 90 degrees or more. Please don't forget to buy the small connection of the faucet (short connection of the faucet) when placing the basin to drain water. Please don't forget to flush the pipe embedded in the wall in advance before you install it.


Installation of shower and bathtub faucet (hanging wall)


When you buy a shower, bathtub, wall faucet, you can choose the height of the embedded outlet pipe. The distance between hot and cold water pipes must reach 15 cm. Do not forget to flush the water pipe before installation, so as to avoid the water quality being too hard and damaging the faucet.

开平不锈钢水龙头厂家

Concealed shower and Bathtub Faucet: after purchasing concealed faucet, the valve core of faucet should be embedded in the wall. Pay attention to the thickness of toilet wall before embedding. If the wall is too thin, the valve core will not be embedded. It is not convenient to remove the plastic cover of the valve core when embedding, so as to avoid the damage of the valve core by cement and other miscellaneous matters. Other in the embedded valve core should also pay attention to the valve core up and down, left and right deviation, in order to avoid the valve core buried wrong. If the size of the water inlet pipe embedded in the wall mounted faucet is defective, it can be used to adjust the position of the faucet.


Placement of thermostatic faucet


Before installing the thermostatic faucet, please check whether the water pipe is hot on the left and cold on the right. Remember not to connect the hot and cold water pipes in the wrong way, so as to avoid that the faucet can not work normally. Gas, solar water heaters can not use thermostatic faucets, because the water pressure is too low. Please don't forget to install hot and cold water filters when installing thermostatic faucets.


Installation of Single Hole Kitchen Faucet


It is required to be stable. Since the kitchen faucet is frequently used and moved from left to right, it is easy to loosen, so the locking nut must be tightened. Now, there are some faucets on the market for the screw pipe, and the nut is firm. The result of this kind of stabilization is very good. If the problem of removing water and pulling can be handled, it will be a popular trend in the future.

The article comes from Kaiping stainless steel faucet manufacturerhttp://www.llg365.com

Navigation Call About Product