The trilogy of keeping the tap open

2020-08-08 10:03:49

I. simple and clean tap

Faucet washing is not huge, as long as it is often connected, it can make the tap as new for a long time.

1. If it is a copper faucet, if you want to clean the electroplating appearance, you can use boiling water and detergent to scrub, or you can directly use some powerful detergent to remove oil and dirt.

2. The scale and rust on the tap can be wiped with a wet cloth or sponge dipped with a little special detergent, and then dried with a clean cloth or washed with water.

3. Dip the toothpaste with a soft toothbrush, and wipe it gently with a clean cloth dipped in toothpaste. The scale and oil stains can be removed, and the appearance of the faucet is clean and bright.

4. Many people only pay attention to the appearance of the faucet when they clean the faucet, but the inside of the faucet is more tense. If the water output of the faucet is eliminated or the water outlet bifurcates, it is probably caused by the blockage of the bubbler. The bubbler can be removed, soaked in vinegar, cleaned with a small brush or other things, and then relocated.


Second, the tap is clean and meticulous

Although the faucet chrome coating claims to be corrosion-resistant and does not rust, but the absolute clean essentials, will still lead to faucet wear.

1. Do not use steel ball and other hard objects to wipe the appearance of the faucet, because the steel ball is very hard, it is easy to scratch the appearance of the faucet.

2. It should be cleaned with neutral detergent. The cleaner with strong acid-base property is not practical and the faucet is clean.

3. After the faucet is clean, dry towel with no hair loss should be used to wipe the remaining moisture on the appearance to avoid residual water stains.

3. Tap maintenance ability

1. Do not use too much force to switch the faucet, just turn it gently. Even if it's a traditional faucet, it doesn't need a lot of effort to screw it. In particular, do not use the handle as a armrest to support or use.

2. The metal hose of the shower faucet should be connected to the natural spreading state, and it should not be coiled on the faucet. At the same time, in use or not, careful hose and valve body discussion do not form a dead angle, in order to avoid breaking or damaging the hose.

3. When the water pressure is not lower than 0.02 MPa (i.e. 0.2 kgf / cm2), after using for a period of time, if the water yield decreases or even the water heater turns off, the screen cover can be gently unscrewed at the water outlet of the faucet to remove the impurities, which can be recovered as before.

4. Ask the staff with resume and qualification to arrange the construction. When installing, the faucet should be only concerned, even if do not collide with hard objects, do not leave cement, glue and other residues in the appearance, so as not to damage the appearance of the coating light. To carefully remove the debris in the pipe before installing the faucet.

The article comes from Kaiping stainless steel faucet manufacturer

Navigation Call About Product